11
Presserfoot
With standard presser foot 10 use setting ”A”
on the spring loaded presser foot latch for the
cover stitch (Prog. 02), the 2 thread chainstitch
(Prog. 01), the 5 thread safety stitch seam
(Prog. 09) and the 4 thread safety stitch seam
(Prog. 08).
Transparent presser foot F from the accessories
can also be used for the cover stitch (Prog. 02).
For all other programs use standard presser
foot 10 and setting ”B” on the springloaded
presser foot latch.
Changing the presser foot
Turn off the electrical power
To remove: Raise the needle(s) to the highest
position by turning the hand wheel towards
you. Raise the presser foot and press lever A at
the rear of the presser foot holder. The presser
foot will be released automatically from the
holder. Pivot the presser foot clockwise until
the front half of presser foot clears holder and
remove by sliding foot away from you towards
back of machine.
To attach: Place the presser foot behind and
perpendicular to the presser foot holder. Pivot
the presser foot counterclockwise until the pin
of the foot is directly under the presser foot
holder clamp. Lower the presser foot lever and
press lever A, if necessary, until the foot then
clicks into place.
Check: Please lift the presser foot lever to
ensure that the presser foot is properly locked
into place.
To Next Page
Loading...
Need help?
General
