38
Adjusting the stitch length
You can set the desired stitch length between
0.5 mm to 4.0 mm by turning the stitch length
adjustment knob (42).
Note:
For the two thread chainstitch, the setting
should be 3.0 or higher.
Removing the needle plate
Raise the presser foot and move the needle(s)
to the highest position. Remove the presser
foot and open the swivel plate. Press down the
needle plate disengaging lever 26. The needle
plate 11 is raised out of its mount. The needle
plate can be removed to the left.
Note:
The machine should be unthreaded when remo-
ving the needle plate.
Inserting the needle plate
Place the needle plate to the rear on the guide
pin (A) and press down at the front until you
hear it click into place.
To Next Page
Loading...
Need help?
General
