10
Spool disc/cone thread adapter
It is advantageous to use the spool disc 37
when sewing with large spools (5,000 - 10,000
m). To do this, place the cone thread adapter 36
onto the spool pin 35. With synthetic threads,
the spool discs help eliminate vibration of the
cones/spools aiding in smoother feeding of the
threads.
Clip on thread guide
Use the clip on thread guide accessory when
sewing with decorative thread. Clip this onto
the telescoping thread guide 32 and thread the
machine as shown in the illustration. Use the
thread net and/or the thread unreeling disc if
needed.
Presser foot lifter
The presser foot can be raised and lowered
using the presser foot lifter 43. The maximum
vertical lift of 6.5 mm for the presser foot for
particularly thick fabrics can be achieved by
pressing the presser foot lifter towards the rear.
Once an initial thread chain has been created,
the presser foot lifter no longer needs to be
raised if you continue working with the same
thread and presser foot. It is suffi cient to gently
lift the front part of the presser foot using your
thumb. Slide the fabric under the raised part
of the presser foot. The fabric is automatically
taken up and fed into the machine when you
activate the foot control.
To Next Page
Loading...
Need help?
General
