6
B
C
D
Operate your Pfaff select
Winding from the second spool holder
Push the second spool holder (7) into its
hole and place a spool of thread with the
corresponding spool cap on it.
Threading
Place the thread into guide C and pull it
through opening B to the right under hook D.
Wind the thread clockwise a few times around
the bobbin.
Switch on the main switch
Hold the end of thread fi rmly and press the
the foot control. The winding action will stop
automatically as soon as the bobbin is full.
Cut the thread, push the bobbin to the left and
remove it.
Don’t forget:
Turn the handwheel release disk (3) fully back
again. Then turn the handwheel (4) towards
you until it snaps into place.
TIP: If the machine is already threaded, you
can easily wind thread from the second spool
holder without having to unthread the machine.
To Next Page
Loading...
