15
A
A
A
Operate your Pfaff select
Changing the needle
Switch off the main switch
To remove: Lower the presser foot
and move the needle to its highest
point. Now loosen the fi xing screw
(18) and pull the needle downwards.
To insert: The fl at side A of the needle
must face to the rear. Lower the
presser foot and insert the needle,
pushing it up as far as it goes. Hold
the needle and tighten the fi xing screw
(18) fi rmly.
Setting the needle thread tension
Set the required needle thread tension (10)
with the help of the mark A.
The normal setting for sewing is 4 to 5.
For embroidering, darning and buttonhole set
the tension between 2 and 3.
Dropping the feed dog
For certain sewing work, e.g. darning the feed
dog has to be dropped. To do this, open the
bobbin case/hook cover and move slide A fully
to the right. Now the feed dog is dropped.
To Next Page
Loading...
