9
Operate your Pfaff select
Inserting the bobbin
Insert the full bobbin into the bobbin case. In
doing so, pull the thread sideways through slot
A, then under the tension plate B until it rests in
the opening (see arrow).
Check: When you look at the bobbin and pull
the thread, the bobbin must turn clockwise.
Inserting the bobbin case
Lift lever F and slide the bobbin case onto the
hook pin D as far as it will go. Opening E of the
bobbin case must face upwards.
Check: Pull the bobbin thread sharply. The
bobbin case must not fall out of the hook.
To Next Page
Loading...
