ENG
Operating Manual | Attachment and Installation Cooling Units | Standard Controller (SC) – 400 V, 2~ | 086100115 5/68
1.3 Target group
The different activities for handling the unit must be allocated to the target groups.
The necessary personnel qualifications are subject to different legal requirements according to the application site. The owner
must ensure that the applicable laws are observed. The admissible personnel and their minimum qualification are defined below
insofar as this is not regulated by law.
Observe the following points:
• Work on or with the unit/system may only be performed by suitable specialists.
• The personnel must be familiar with the pertinent standards, regulations, rules for the prevention of accidents and
operating conditions.
• The personnel must be instructed and trained for the work to be performed.
• The personnel must be capable of recognizing and avoiding hazards.
Person Activity Qualification Life phase
Load transport specialists
Lifting/setting down and
transporting the system
Proven experience in the
handling of suspended loads
and load securing
Transport, disposal
Specialized personnel
(mechanics)
Mechanical work for:
Commissioning,
troubleshooting, maintenance
and decommissioning
Training as industrial
mechanics or an equivalent
professional qualification
Commissioning,
maintenance,
troubleshooting,
decommissioning,
disassembly
Specialized personnel
(electrician)
Electrical work
Professional training in
electrical engineering or an
equivalent professional
qualification
Commissioning,
maintenance,
troubleshooting,
decommissioning,
disassembly
Operators and users Operation of the system By the owner based on the
instruction of an instructed
person
Commissioning, operation,
maintenance, troubleshooting
Specialized personnel
(disposal agent)
Proper disposal of the system
Knowledge of the disposal
regulations applicable at the
application site
Decommissioning,
disassembly, disposal
Tab. 1: Target groups and required personnel qualification
To Next Page
Loading...
