Copy template
14.1 Test log for nominal hole widths
This log is intended to allow the owner-operator to document the test status of the SORTIMAT laboratory
sorting machine.
Company, location
SORTIMAT type:
Year of manufacture:
Serial number:
Checking the nominal hole widths
Nominal hole width – tolerances for sieve plates:
Slot: ISO 5223 Test sieves for cereals
Round hole: DIN ISO 3310-2 Test sieves – Technical requirements and testing –
Part 2: Test sieves of perforated metal plate
Nominal hole width as embossed: mm specified tolerance: mm
Actual hole widths:
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29
1
2
3
4
5
6
7
8
9
10
11
The tester confirms that the measurement has been carried out correctly as described in the operating
instructions in chapter 14.
The nominal hole widths correspond to the actual hole widths:
Yes No
The sieve meets the requirements stated in the aforementioned regulations:
Yes No
Place, date Name, position Signature
Company stamp:
To Next Page
Loading...
