S-DRIVE - INSTALLATION PG DRIVES TECHNOLOGY
SK76745/10
3 Connections
3.1 General
Study the data sheet for the controller to identify:
The output current, ratings and restrictions
The connector pin assignments
Recommendations for the cross-sectional area, ratings and materials for wiring are given in the table in section 3.4, these
depend on the application. You are responsible for establishing the suitability of the particular wiring arrangement used on the
scooter. PGDT can make general recommendations for wiring to the S-Drive controller, but PGDT accepts no responsibility for the
wiring arrangement used.
Make sure that the connectors you use are reliable under all operating conditions and correctly wired with no short circuits. Do
not use unsuitable components - it may result in poor scooter reliability. Refer to the following illustration for a basic connection
detail.
The scooter manufacturer is responsible for establishing the suitability of the particular wiring
arrangements used on the scooter, for both normal use and stalled conditions. PGDT can make
general recommendations for wiring the S-Drive Scooter Controller, but PGDT accepts no
responsibility for, and accepts no liability for losses of any kind arising from, the actual wiring
arrangement used.
The scooter manufacturer is responsible for ensuring that only the mating connectors specified by
PGDT on the controller’s specific data sheet or in this manual are used to connect to the
controller. PGDT accepts no liability for losses of any kind arising from failure to comply with
this condition.
The scooter manufacturer is responsible for ensuring that suitable connectors are used and
securely mated throughout the scooter wiring system and that the workmanship associated with
the wiring system is of a good enough quality. Failure to meet this condition could result in
intermittent operation, sudden stopping or veering, or even create a burn or fire hazard. PGDT
accepts no liability for losses of any kind arising from failure to comply with this condition
To Next Page
Loading...
