S-DRIVE – OPERATION                   PG DRIVES TECHNOLOGY 
SK76745/10 
Do  not  operate  the  scooter  if  the  battery  is  nearly  discharged.  Failure  to  comply  with  this 
condition  may  leave  the  user  stranded  in  an  unsafe  position,  such  as  in  the  middle  of  a  road. 
PGDT accepts no liability for losses of any kind arising from failure to comply with this condition 
8.2.3  TruCharge Indicator Stepping Up  
The scooter’s batteries are being charged. 
8.2.4  TruCharge Indicator blinks on every 3.5 seconds   
The controller has entered Sleep Mode. 
8.2.5  TruCharge Indicator Flashing Rapidly 
The controller safety circuits have operated and the controller has been prevented from moving the scooter. 
This indicates that there is a trip. Please follow this procedure: 
  Switch off the scooter. 
  Make sure that all connectors on the scooter are mated securely. 
  Check the condition of the battery. 
  If you can’t find the problem, try using the self-help guide in section 8.3. 
  Switch the scooter on again and try to drive. If the safety circuits operate again, switch off and do not try to use 
the scooter.  
  Contact your service agent. 
If a system trip occurs you can find out what has happened by counting the number of bars that are flashing on the TruCharge 
Indicator. Refer to section 8.3. 
8.3  Self-Help Guide 
Below is a list of self-help actions. Try to use the following table before you contact your service agent. Go to the number in the list 
that matches the number of flashing bars and follow the instructions.