PG DRIVES TECHNOLOGY S-DRIVE - PROGRAMMING
SK76745/10
4 Alternative single flash repeated code sequence. See following diagram
For details of the TruCharge and sequence indication of these settings refer to Chapter 1 section 8.
7.6 Reverse Alarm
The alarm will sound whenever the scooter is being reversed. On single ended throttle scooters the alarm will be activated when
the reverse switch is activated.
The parameter can be set to On or Off.
7.7 Reverse Alarm Tone
This parameter sets the tone when the alarm is active. The parameter can be programmed to 0, 1, 2 or 3.
0 ā Self Resonating 1 - 2khz 2 - 1kHz 3 - 500hz
7.8 Pulse Reverse Alarm
The controller has an output to power an audible reversing alarm. The alarm will sound whenever the scooter is being reversed.
On single ended throttle scooters the alarm will be activated when the reverse switch is activated.
To Next Page
Loading...
