S-DRIVE - WARNING SUMMARY PG DRIVES TECHNOLOGY
SK76745/10
2.10 Program Settings
Programming should only be conducted by healthcare professionals with in-depth knowledge of
PGDT electronic controllers. Incorrect programming could result in an unsafe setup of a scooter
for the user. PGDT accepts no liability for losses of any kind if the programming of the controller
is altered from factory pre-set values. PGDT accepts no liability for losses of any kind if the drive
or stability characteristics of the chair are altered without prior notification and discussion with
PGDT. Chapter 2 section 1.2.
2.11 Charger Interlock
The scooter manufacturer is responsible for providing a means of preventing the use of the
scooter while the batteries are being charged. PGDT accepts no liability for losses of any kind
arising from failure to comply with this condition. Chapter 2 section 2.2.
2.12 Connections - General
The scooter manufacturer is responsible for establishing the suitability of the particular wiring
arrangements used on the scooter, for both normal use and stalled conditions. PGDT can make
general recommendations for wiring the S-Drive Scooter Controller, but PGDT accepts no
responsibility for, and accepts no liability for losses of any kind arising from, the actual wiring
arrangement used.
The scooter manufacturer is responsible for ensuring that only the mating connectors specified by
PGDT on the controller’s specific data sheet or in this manual are used to connect to the
controller. PGDT accepts no liability for losses of any kind arising from failure to comply with
this condition.
The scooter manufacturer is responsible for ensuring that suitable connectors are used and
securely mated throughout the scooter wiring system and that the workmanship associated with
the wiring system is of a good enough quality. Failure to meet this condition could result in
intermittent operation, sudden stopping or veering, or even create a burn or fire hazard. PGDT
accepts no liability for losses of any kind arising from failure to comply with this condition.
Chapter 2 section 3.1.
2.13 Battery and Motor Connections
S45A, S70A & S90A
It is the responsibility of the scooter manufacturer to ensure that the mating male Fastons are
suitable for use on the intended application. All connectors should be fitted with the appropriate
boot. PGDT accepts no liability for losses of any kind arising from failure to comply with this
condition. Chapter 2 section 3.2.1.1.
S200A
It is the responsibility of the scooter manufacturer to ensure that the high current crimp
connections are suitable for use on the intended application. PGDT accepts no liability for losses
of any kind arising from failure to comply with this condition. Chapter 2 section 3.2.1.3.
To Next Page
Loading...
Need help?
General
