S-DRIVE - WARNING SUMMARY PG DRIVES TECHNOLOGY
SK76745/10
1 Introduction
This section summarizes all of the very important warnings that appear throughout the text of this manual. Do not install, maintain
or operate the scooter without reading, understanding and observing the following warnings. Failure to observe these warnings
could result in UNSAFE CONDITIONS for the user of a scooter or affect the reliability of the controller. PG Drives Technology accepts
no liability for losses of any kind arising from failure to comply with any of the conditions in the warnings listed below. Failure to
observe these warnings will invalidate the S-Drive warranty.
The scooter manufacturer may wish to use this section as a check list, to ensure the risk areas
identified below have been addressed within their own scooter designs and associated
documentation.
2 Warnings
2.1 Driving Technique
The scooter user must be capable of driving a scooter safely. PGDT accepts no liability for losses
of any kind arising from failure to comply with this condition. Chapter 1 section 5.2.
2.2 Hazards
Although the S-drive is designed to be extremely reliable and each unit is rigorously tested during
manufacture, the possibility of system malfunction always exists (however small the probability).
Under some conditions of system malfunction the control system must (for safety reasons) stop
the scooter instantaneously. If there is any possibility of the user falling out of the scooter as a
result of a sudden braking action, it is imperative that a restraining device such as a seat belt is
supplied with the scooter and that it is in use at all times when the scooter is in motion. PGDT
accept no liability for losses of any kind arising from the unexpected stopping of the scooter, or
arising from the improper use of the scooter or control system.
Do not operate the S-Drive if the scooter behaves erratically, or shows abnormal signs of
heating, sparks or smoke. Turn the S-Drive off at once and consult your service agent. PGDT
accepts no liability for losses of any kind arising from failure to comply with this condition.
Electronic equipment can be affected by Electro Magnetic Interference (EMI). Such interference
may be generated by radio stations, TV stations, other radio transmitters and cellular phones. If
the chair exhibits erratic behavior due to EMI, turn the control system off immediately and consult
your service agent. PGDT accepts no liability for losses of any kind arising from failure to comply
with this condition
.
It is the responsibility of the scooter manufacturer to ensure that the scooter complies with
appropriate National and International EMC legislation. PGDT accepts no liability for losses of
any kind arising from failure to comply with this condition.
The scooter user must comply with all scooter safety warnings. PGDT accepts no liability for
losses of any kind arising from failure to comply with this condition. Chapter 1 section 6.1.
To Next Page
Loading...
