PG DRIVES TECHNOLOGY S-DRIVE – WARNING SUMMARY
SK76745/10
2.25 Inhibit 1 Speed Limit Value
If the Inhibit Speed is greater than 0 then the controller will not enter an inhibit state. Chapter 2
section 6.1.2.
2.26 Position
Under strenuous driving conditions it is possible for metal sections of the controller’s case to
exceed 41°C (106 °F) in temperature. Under such conditions, the scooter manufacturer should
ensure that either the user cannot touch these surfaces, or that the user is warned not to touch
these surfaces. While 41°C (106 °F) is very close to normal body temperature, prolonged contact
with surfaces above 41°C (106 °F) can result in burns to the skin. PGDT accepts no liability for
losses of any kind arising from failure to comply with this condition. Chapter 2 section 8.1.4 &
8.2.4
2.27 Production Tests
This test should be conducted in an open space and a restraining device such as a seat belt
should always be used. PGDT accepts no liability for losses of any kind arising from failure to
comply with this condition. Chapter 2 section 10.
2.28 Program Settings
Programming should only be conducted by healthcare professionals with in-depth knowledge of
PGDT electronic controllers. Incorrect programming could result in an unsafe setup of a scooter
for the user. PGDT accepts no liability for losses of any kind if the programming of the controller
is altered from factory pre-set values. PGDT accepts no liability for losses of any kind if the drive
or stability characteristics of the chair are altered without prior notification and discussion with
PGDT. Chapter 3 section 1.3.
2.29 Introduction
Programming should only be conducted by healthcare professionals with in-depth knowledge of
PGDT control systems. Incorrect programming could result in an unsafe set-up of a wheelchair
for a user. PGDT accept no responsibility for losses of any kind if the programming of the control
system is altered from the factory pre-set values. Chapter 3 section 1.
2.30 Safety Fences
PGDT accepts no liability for losses of any kind if the scooter manufacturer does not specify
appropriate safety fence values for a particular scooter application. Chapter 3 section 1.4.
2.31 Forward Acceleration
Setting this value too high could cause the scooter to tip when accelerating up a slope. Chapter 3
section 2.1.
To Next Page
Loading...
