24 25
D-RGB CABLES
D-RGB CONTROLLER
The built-in D-RGB controller has 2 channels (A & B). Both
channels, each with 2 available D-RGB ports, can be controlled
seperately with the control buttons on the front I/O.
max 7A per channel, max 4A per port
LIGHTING EFFECTS & CONTROLS
D-RGB Lighting effects and control instructions are described
on page 6.
INSTALLING STORAGE
Loosen the thumb screw to open the top door.
Install up to 2x 2.5’’ drives with
2x SSD screws per SSD.
TOP DOOR STORAGE
Connect the 2x SATA cables to the power supply.
The D-RGB to motherboard cable is included in the accessory
box.
sync lighting to
the motherboard
To Phanteks Digital-RGB products (JST connector)
02
EXPAND WITH OTHER D-RGB PRODUCTS
01
CONNECT THE SATA CABLES
01
OPEN TOP DOOR
02
INSTALL 2.5’’ DRIVES
03
SYNC LIGHTING TO MOTHERBOARD (OPTIONAL)
CHANNEL A PORTS
TO SATA PSU
TO TOP IO PANEL
CHANNEL B PORTS
SYNC TO MOTHERBOARD
2.5’’ DRIVE
2.5’’ DRIVE
THUMB SCREW 1x
LOOSEN
SSD SCREW 4x
INSTALL
channel A
SATA
channel B
SATA
cable routing
To Next Page
Loading...
