28 29
INSTALLING LED COVERS INSTALLING LED COVERS
Option 1: Default
The rst option covers a bit more of the cables attached to
the motherboard, and is a great t for standard sized ATX
motherboards.
The motherboard cover can be installed in two ways:
01
INSTALL MOTHERBOARD COVER
Option 2: Reversed
For the second option, the cover is installed in reversed position.
This covers less of the motherboard and allows more clearance
for E-ATX motherboards (up to 277 mm).
Option 3: Remove Cover
For even larger motherboards and maximum clearance, it is recommended to remove this cover completely.
Slide the D-RGB cover to the rear of the chassis to install it.
INSTALL D-RGB COVER
02
1.
After choosing the preferred position, align the motherboard
cover (1) and slide upwards (2). Secure it with the thumb screw
through the right side of the chassis (3).
3. secure with
thumbscrew
E-ATX (up to 277 mm)
ATX
2.
1.
To Next Page
Loading...
