What to do if my Phcbi Accessories unit does not operate?
If your Phcbi Accessories unit isn't operating, make sure it's correctly plugged into a power outlet. Also, check the circuit breaker at the power source or whether there has been a power failure.
Why is CO2 consumption too high in my Phcbi MCO-80ICL Accessories?
Excessive CO2 consumption in your Phcbi Accessories could be due to several reasons: * The door is opened frequently. * There is any gas leakage at the connection or pin hole on the tube. It is recommended to replace the tube once a year. * An access port is opened.
What to do if chamber humidity does not rise in Phcbi Accessories?
If the chamber humidity isn't rising, make sure the water reservoir is filled with sterile distilled water and that the no humidifying mode is not active.
Why does it take so long to recover the gas density in Phcbi MCO-80ICL?
If the gas density takes a long time to recover, even with normal gas pressure, the HEPA filter in the gas piping may be clogged with dust, preventing proper gas flow.
Why is CO2 gas not being injected in my Phcbi MCO-80ICL?
The CO2 injection system is ON-OFF controlled and injects gas intermittently when the set density is close. Injection might stop for 15 seconds but it is not abnormal.
Overview of the control panel and keypad functions, including indicators and keys.
Details the function and connection of the remote alarm output terminal.
Provides instructions and safety warnings for connecting the CO2 gas cylinder.
Procedure for cleaning and sterilizing the incubator chamber and its internal parts.
Step-by-step guide to calibrate the temperature control system of the incubator.
Procedure for calibrating the CO2 density control system for accurate measurements.
General| Model | MCO-80ICL |
|---|---|
| Brand | PHCbi |
| Capacity | 80 L |
| CO2 Range | 0% to 20% |
| Humidity Range | 40 to 95% RH |
To Next Page