www.phicomm.com
Access Control
MAC/IP/Port Filter
This page is used to enable the firewall filtering function, select the filtering service or manually
set the parameters that need to be filtered, such as MAC address, IP address and Port. You must
set at least one filtering condition. You may also set multiple conditions or all the conditions.
MAC/IP/Port Filter: Select Enabled or Disabled to enable or disable filter.
Default Policy：Accepted chose, all the packets and devices will be allowed to be passed
normally, opposite action will be happened if Dropped was been chosen.
Current IP/Port Filtering Rules: All the existing rules will be listed below, any needed of rules
To Next Page
Loading...
