190CW9 LCD 67
General Product Specification
ʳ
ʳʳʳʳ
ʳʳʳʳʳʳʳʳ
ʳʳʳʳʳ
ʳʳ
ʳ
ʳ
.16.1. Demo mode
A. Purpose: Built-in demo mode for sales in-store demo.
B. Design:
i. Dynamically split screen to 2 vertical frames with one vertical white line.
The line width is 2 pixels. The left frame will be enhanced by SmartImage
Lite and right frame remains original performance.
ii. There is OSD showing “SmartImage Lite & SmartResponse Demonstration”
in left frame and “Original Image” in right frame.
iii. The OSD word color is white with transparent background.
iv. The demo profile will be “Video Playback” profile with “High” ODC setting.
v. The current SmartContrast value also be shown on the bottom of the
screen.
C. Hot keys to trigger:
Press [Smart Image] 3 seconds or more to trigger the demo mode.
When demo mode is On, press 3 seconds or more to turn off the demo mode.
When the demo mode is enabled, the blue LED will flash until demo mode disabled.
4 Visual characteristics
4.1 Test conditions
Unless otherwise specified, this specification is defined
under the following conditions.
(1) Input signal : As defined in 3.3, 1440*900
non-interlaced mode (1440*900@60Hz 146.25MHz),
signal
sources must have 75 ohm output impedance.
(2) Luminance setting : controls to be set to 300 nits with
full screen 100 % duty cycle white signal
(3) Warm up: more than 30 minutes after power on with signal supplied.
(4) Ambient light: 400 -- 600 lux.
(5) Ambient temperature: 20 ± 5 °C
4.2 Brightness
To follow Panel specification.
http://www.wjel.net
To Next Page
Loading...
