Philips 190CW9FB/69 - If Paint Is Used; Plastic Mold Tooling; Plastics Flammability; Texture;Glossing of Housing

70 190CW9 LCD
General Product Specification
ʳ
5. If paint is used
• RoHS required
• WEEE require
• If new painting type need to implement, refer to UN-D 1235.
5.9 Plastic mold tooling
• Tooling to be designed to minimize cosmetic defects induced by molding process
(sink, blush, weld lines, gate marks, ejector marks, etc.). Refer to “TYV61-90007”.
• Painting to cover up cosmetic defects due to molding is strongly discouraged.
• China RoHS mark requested.
5.10 Plastics flammability
• All Plastics to be Flame Retardant UL 94-V0 or Better (if monitor weighs less than
18kg; UL94-V0 is OK).
• Base / Pedestal to be Flame Retardant UL 94-HB.
• All major plastic parts (bezel, back cover) need to be molded from same resin.
• ABS V0 is allowed to implement in China region for monitor body major plastic
parts (bezel, back cover).
• Plastic resin type selection should be referred to “TY R83-2-9002-1”.
5.11 Texture/Glossing of housing
• The texture area and texture no should follow Philips make-up sheet.
• The exterior surfaces shall have a uniform texture.
• Philips must approve the mold texturing.
• Detail document for texture refer to “UN-D249”, “UN-D 600”.
5.12 Tilt and swivel base
• Tilt angle : -5 ° +2/- 0 ° (forward)
+20 °+3/- 0 ° (backward)
http://www.wjel.net