ġ
ġ
ġ
ġ
72 19B4LP LCD
ġ
5.3 Location of Philips logo -
Per Philips make-up sheet
5.4 Gap between panel and front bezel
< 0.8mm (Typ.)
5.5 Location of Control icons -
Per Philips Graphic sheet
5.6 Color for resin/paint -
Per Philips make-up sheet
5.7 Fire enclosure request
Shielding Cover should fulfill international standard
5.8 Resins
x RoHS required
x WEEE required.
x Resin type/selection refers to Project Book Section 7.2 Plastic material.
5.9 If paint is used
x RoHS required
x WEEE require
x If new painting (option, refer to Quick specification table) type need to implement, refer to
UN-D 1235.
5.10 Plastic mold tooling
x Tooling to be designed to minimize cosmetic defects induced by molding process (sink, blush,
weld lines, gate marks, ejector marks, etc.). Refer to “TYV61-90007”.
x Painting to cover up cosmetic defects due to molding is strongly discouraged.
x China RoHS mark requested.
5.11 Plastics flammability
x All Plastics to be Flame Retardant UL 94-HB or Better.
x Base / Pedestal to be Flame Retardant UL 94-HB.
x All major plastic parts (bezel, back cover) need to be molded from same resin.
x Plastic resin type selection should be referred to “plastic-Philips Pool monitor”.
To Next Page
Loading...
