Philips 49BDL3005X - Page 46

BDL4988XC/49BDL3005X
36
How to setup the settings in the menu to
control all the monitors at the same time and
individually via RC?
DaisychainedbyRS232andnoIRcable 1.Therstdisplaysetsas“Primary”onOSD
(Advancedoption/IRcontrolitem),otherssetas
“Secondary”.
2.ThesetupOSDwillshowontopleftsideof
thedisplay.(ToggleMENUwillshowagainifit
disappears)
3.Defaultsetting:IDNO:0,GPNO:0,thissetting
cancontrolalldisplaysbyIR.
The“+”,“-”canchange“IDNO”tocontrol
signaldisplayby“MonitorID”.
The“UP”,“DOWN”canchange“GPNO”to
controlmulti-displayby“GroupID”.
*TherstdisplayisalwayscontrolledbyIR.
How does the RC work? Daisychain:noconnectionofRS232andIR
cable
Nosettingisrequired.ConnectwithIRcables
andcontrolbyIR.
*Thismaycauseout-of-synchronizm
phenomenon.Itissuggestedtousetheabove
settingswithRS-232cable.