15
English
English
Pumping instructions
Warning: Always switch off the breast pump before you remove the pump body from
your breast, in order to release the vacuum.
Warning: Do not continue pumping for more than five minutes at a time if you do not
succeed in expressing any milk. Try to express at another time during the day.
Warning: If the process becomes very uncomfortable or painful, stop using the breast
pump and consult your healthcare professional.
Note: If you regularly express more than 125ml/4floz per session, you can purchase and use a
260ml/9floz Philips Avent Natural bottle to prevent overfilling and spillage.
1. Wash your hands
thoroughly with soap
and water and make
sure that your breast is
clean.
2. Place the breast pump
kit onto your breast.
Make sure that you
center your nipple.
3. Press and hold the
on/off button until the
device switches on. The
indicator lights go on to
indicate that the device
is in stimulation mode.
4. The breast pump starts
in stimulation mode and
slowly increases its
vacuum to the last used
stimulation suction level
(or level 5 when used for
the first time).
5. Use the 'level up' and
'level down' buttons to
change the suction level
to your preference.
6. After 90 seconds the
breast pump will switch
smoothly to expression
mode and slowly
increase its vacuum to
the last used expression
suction level (or level 11
when used for the first
time).
7. If your milk starts
flowing earlier or if you
want to switch from
expression to stimulation
mode, you can switch
modes with the mode
selection button.
8. Briefly press the on/off
button if you want to
pause. To continue,
briefly press the on/off
button again.
To Next Page
Loading...
