Philips AVENT SCD973 - Compliance Information; Radio Interference; RF Radiation Exposure Statement

- 52 -
Compliance information
This device complies with Part 15 of the FCC Rules and contains licence-
exempt transmitter(s)/receiver(s) that comply with Innovation, Science
and Economic Development Canada’s licence-exempt RSS(s). Operation
is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Radio interference
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules and
ICES-003 of Innovation, Science and Economic Development Canada’s
licence-exempt RSS(s). These limits are designed to provide reasonable
protection against harmful interference in a residential installation� This
equipment generates, uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation� If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment o and on,
the user is encouraged to try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna�
- Increase the separation between the equipment and receiver�
- Connect the equipment to an outlet on a circuit dierent from that to
which the receiver is connected�
- Consult the dealer or an experienced radio/TV technician for help.
RF Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth
for an uncontrolled environment� This equipment should be installed
and operated with a minimum distance of 7 3/4 inches / 20 centimeters
between the radiator and your body. For handheld/body-worn operation,
this equipment has been tested and meets the FCC RF/Innovation,
Science and Economic Development Canada’s licence-exempt RSS(s)
RF exposure guideline when used with the belt clip supplied with this
product�
Canada:
This device contains licence-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s licence-
exempt RSS(s). Operation is subject to the following two conditions:
(1)this device may not cause harmful interference, and (2) This device
must accept any interference received, including interference that may
cause undesired operation of the device�
CAN ICES-3(B)/NMB-3(B)