Philips BDS4223V - Connecting a DVD Player

User Manual BDS4223V
18
5.2 CONNECTING A DVD PLAYER
Using Component Video Input
1 Connect the green-colored (labeled as "Y") jack from the DVD
player to the green-colored "Y1" jack of the monitor.
2 Connect the red-colored (labeled as "PR" or "CR") jack from the
DVD player to the red-colored "PR1/CR1" jack of the monitor.
3 Connect the blue-colored (labeled as "PB" or "CB") jack from the
DVD player to the blue-colored "PB1/CB1" jack of the monitor.
4 Connect the red (R) and white (L) audio jacks from the DVD player
to the R and L audio-in jacks located next to the "PR1/CR1"
connector.
Note:
There are two sets of component inputs provided. You can use either
set to connect your DVD player.
Using S-Video Input
1 Connect the S-Video (4-pin DIN) connector from the DVD player to
the "S-VIDEO" input on the back of monitor.
2 Connect the red (R) and white (L) audio jacks from the DVD player
to the R and L audio-in jacks located next to the S-VIDEO
connector.
Note:
There are two sets of S-Video inputs provided. You can use either set to
connect your DVD player.
Using Composite (AV) Video Input
1 Connect the "yellow" (video) connector from the DVD player to the
yellow "VIDEO 1" input on the back of monitor.
2 Connect the red (R) and white (L) audio jacks from the DVD player
to the R and L audio-in jacks located next to the yellow "VIDEO 1"
connector.
Note:
There are two sets of composite inputs provided. You can use either set
to connect your DVD player.
DVD PLAYER
Component Video
(3xRCA cable)
Audio L/R
(2xRCA cables)
DVD PLAYER
Audio L/R
(2xRCA cables)
S-Video
(4-Pin-DIN)
DVD PLAYER
Video
(RCA cable)
Audio L/R
(2xRCA cables)