User Manual BDS4223V
45
7.5 SETTING POWER SAVE MODE
Using OSD Menu
This monitor is equipped with a Power Save mode under RGB input
modes. When there are no signals detected by the monitor, the monitor
will automatically go into sleep mode until signal is restored.
1 Press the MENU on the monitor panel or remote control.
2 Use the SEL or SEL key to select the SETUP option from the
menu.
3 Press the ADJ key to confirm the selection.
=> Various options are available in the SETUP menu.
4 Use the SEL or SEL key to select the POWER SAVE option
5 Press the ADJ
key to confirm selection.
=> The POWER SAVE menu appears.
6 Use the ADJ or ADJ key to select the desired amount of time
to power down when no signal is detected (1MIN, 2MIN, 3MIN,
4MIN and 5MIN).
7 Press the SEL key to confirm setting and return to previous
menu.
Note:
To turn on the monitor from sleep mode, simply follow Power On
procedure.
To Next Page
Loading...
