Philips BJ3.1E LA - Page 14

Mechanical Instructions
EN 14 BJ3.1E LA4.
LCD 37” models
1. Unplug the connectors [1] from the LCD Inverters, the
loudspeakers, the LED/IR board, the Keyboard Control
board, and (carefully) from the LVDS connector on the
display.
2. Remove the speaker boxes [2], to get access to the screws
that hold the lower side of the metal sub-frame.
3. Remove the screws [3] on top and bottom of the metal sub-
frame.
4. Remove the Main Supply Panel as described earlier to get
access to the screw that holds the LCD panel.
5. Remove and put the complete Side I/O unit on the metal
sub-frame.
6. Remove T20 fixation screws [4] that hold the LCD panel
and lift the complete metal sub-frame (incl. the boards and
cables) from the set.
7. Lift the LCD panel from the front cabinet.
Figure 4-17 LCD panel (37” model)
G_16851_009.eps
080307
3
3
4
4
4
4
2
2
1