15
3 Remove the screws on the both side of
the unit.
4 Remove the mounting sleeve.
5 Install the sleeve into the dashboard and
bend the tabs outward to fi x the sleeve.
Mount in the dashboard
Note
Check wire connection before you mount the unit
into a car.
If preset radio stations are lost when the ignition key
is turned OFF and then back ON, reconnect the red
leads crosswise to the yellow ones.
•
•
1 If the car does not have an on-board drive
or navigation computer, disconnect the
negative terminal of the car battery.
If you disconnect the car battery in
a car that has an on-board drive or
navigation computer, the computer
may lost its memory.
If the car battery is not disconnected,
to avoid short-circuit, ensure that bare
wires do not touch each other.
2 Ensure that car dashboard opening is
within these measurements:
Since the unit cannot be used if the
dashboard opening’s slant angle is
above 20 degrees: Ensure that the
horizontal slant of the car dashboard
opening is between 0 and 20 degrees
•
•
•
183 mm
53.5mm
5mm
183 mm
53.5mm
5mm
Connect reverse driving cable
English
EN
EN.indd Sec1:15EN.indd Sec1:15 2008-11-14 13:23:022008-11-14 13:23:02
To Next Page
Loading...
