Philips DVDR615 - Audio and Recording Settings

Diagnostic Software
EN 37DVDR615/69 5.
Error Number Description
91000 The command executed successfully
91001 There was a time-out while communicating
91002 The Basic Engine returned an unexpected result
91003 The BE returned an error code
91004 No acknowledge received from BE
91005 Communicating with the Basic Engine failed
91006 The BE returned no info
Example (AV2) DS:> 910
Momentary errors (Byte 1 - Byte 7) : 0x00 0x00 0x00 0x00 0x00 0x00 0x00
Cumulative errors (Byte 1 - Byte 7) : 0x00 0x00 0x00 0x20 0x00 0x00 0x00
Fatal errors (Oldest - Youngest) : 0x00 0x00 0x00 0x00 0x00
091000:
Test OK @
Example (AV3) DS:> 910
Momentary errors (0-9): 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00
Cumulative errors (1-9) : 0x00 0x80 0x20 0x00 0x00 0x00 0x00 0x00 0x00
Software fatal assert : 799 engineproxy.cpp
091000:
Test OK @
Nucleus Name DS_BE_ErrorLogReset
Nucleus Number 911
Description Reset the error log in the basic engine
Technical - Check if an AV2 or AV3 is connected
- In case of an AV2
- Send theS2B RESET_STATISTICAL_INFO command
- Send the S2B POWER_DOWN command
- Toggle the reset pin of the I2S interface
- In case of an AV3 Send the transparent BIT engine RESET_STATISTICAL_INFO
command
Execution Time 2 seconds
User Input None
Error Number Description
91100 The command executed successfully
91101 There was a time-out while communicating
91102 The Basic Engine returned an unexpected result
91103 The BE returned an error code
91104 No acknowledge received from BE
91105 Communicating with the Basic Engine failed
Example DS:> 911
091100:
Test OK @
Nucleus Name DS_BE_JitterOptimise
Nucleus Number 912
Description Perform jitter optimisation:
A formatted DVD must be loaded into the engine before executing this nucleus
Technical - Check if an AV2 or AV3 is connected
- Send the TRAY_IN command
- Send the READ_TOC command
- In case of an AV2
- Send the JITTER_COMMAND command with parameter 0x00 0x00
- Send the JITTER_COMMAND command with parameter 0x00 0x01
- Send the JITTER_COMMAND command with parameter 0x00 0x02 until offset
0x80 is received
- In case of an AV3 Send the MEASURE_JITTER_BLER_PPN command and dis-
play the average jitter and bler values
Execution Time Approximately 20 seconds
User Input none
http://www.jdwxzlw.com/?fromuser=华盛维修
家电维修资料网，免费下载各种维修资料