Philips DVDR615 - Recording Features; Recording Basics and Disc Types

Diagnostic Software
EN 57DVDR615/69 5.
123402 Setting the filename was aborted by the user.
Example DS:> 1234
Enter the new Download Table Filename (Currently equals DVDR2001.001)
Enter a filename:
>
The Download Table Filename will be set to: DVDR2001.001.
Is that correct? ([Y/N]):
123402: Setting the filename was aborted by the user.
Error @
DS:> 1234
Enter the new Download Table Filename (Currently equals DVDR2001.001)
Enter a filename:
>DVDR2002.001
The Download Table Filename will be set to: DVDR2002.001. Is that correct? ([Y/N]):Y
123400:
Test OK @
Nucleus Name DS_SYS_IicWriteRead
Nucleus Number 1235
Description Perform an IIC write-read action on the digital board
Technical - Determine bus ID, slave address, number of bytes to be written and the byte
array of data from the user input
- Initialise IIC
- Write the data to the IIC slave
- Read the data from the IIC slave
Execution Time Less than 1 second
User Input The user inputs the Bus ID, Slave Address, number of bytes to read, number of bytes
to write and the bytes to be written
<NucNr><BusId><SlaveAddr><ReadLen><WriteLen><WrByte0...WrByteN>
Max number of bytes to write: 255
Max number of bytes to read: 255
Error Number Description
123500 Writing data to and reading data from the IIC slave
succeeded
123501 The IIC bus was not accessible
123502 There was a bus timeout reading the device
123503 The IIC acknowledge was not received
123504 Unable to initialise IIC bus
123505 The communication with the device failed
123506 Unknown IIC bus error received
123507 Decoding bus ID unsigned value failed
123508 Decoding slave address unsigned value failed
123509 Decoding number of bytes unsigned value failed
123510 Bus ID out of range
123511 Number of bytes out of range
Example DS:> 1235 0 0xa0 0xf 1 0
0x0000: 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00
0x0008:0x00 0x00 0x00 0x00 0x00 0x00 0x00
121000:
Test OK @
Nucleus Name DS_SYS_UartSetup
Nucleus Number 1236
Description Set up a configuration for the selected UART
Technical - Parse user input
- Use MIS_UART_Setup to setup the selected UART with the requested
parameters
Execution Time Less than 1 second
http://www.jdwxzlw.com/?fromuser=华盛维修
家电维修资料网，免费下载各种维修资料