6
Use an audio cable and plug one end into the AUDIO OUT jack
at the back of the DVD Recorder (next to COMPONENT
VIDEO Y PB PR OUT ) and the other into the red/white Audio
In jacks of the TV (usually called Audio in'. 'AV in'. Please see
your TV's instruction manual),
Switch on the TV.
If necessary, set the TV to the Component Video channel.
If necessary, see the operating instructions for your TV. Or, go
to channel zero on your TV, then keep changing channels down
until you see the DVD Recorder screens (when the Recorder is
on). This is not channel 3 or 4 as it would be if you used only
the cable/antenna connection.
7
8
Connect the mains jack _MAINS at the back of the DVD
Recorder with the power supply using the supplied power cable.
The most important features of the DVD Recorder will appear
on the display.
After the initial installation is completed, this function will be
switched off. How you switch on this function again, read in the
chapter 'User preferences' in the section 'Standby'.
Press STANDBY-ON_)on the recorder. 'I_ TY n,,n,u_+r will
appear on the display.
Switching TV and DVD Recorder to 'Progressive scan'
Tile factory settings of the DVD Recorder are set to 'Interlaced'. If you
selected the 'Progressive scan' connection during installation, you must
switch the 'Component Video output' of the DVD Recorder and, if
necessary, the 'Component Video input' of the TV to 'Progressive scan.'
Switching the TV
Please select 'Progressive scan' for the Component Video input on the
TV. If necessary, see your TV instruction manual.
If your" TV is equipped with separate input jacks for Interlaced and
Progressive, connect the DVD Recorder to the jack that supports
'Progressive scan.'
Switching the DVD Recorder
Disconnect the recorder's power cord.
2 Hold down 14_1 on the DVD Recorder while reconnecting the
power cord. 'PRO' (progressive scan) will appear on the display.
3 If you want to switch back, repeat steps 1 and 2. 'PRO'
(progressive scan) will disappear from the display. The DVD
Recorder is switched to 'Interlaced.'
Tip
_.... MAINS :
Then, read the paragraph 'Initial installation' in the chapter 'Installing your DVD recorder'.
Connecting the DVD Recorder 13
To Next Page
Loading...
