Manually setting the time & date
If the time is incorrect, this could be due to a weal< or disrupted TV signal. If this is the case,
switch off the automatic function.
3
4
Press SYSTEM-MENU on the remote control. The menu bar
will appear.
Select 'Tg' using _ or •
Select line 'Installation' using CH-• or CH+ • and confirm
with •.
Select line 'Time/Date' using OH-• or OH+ • and confirm
with •.
Select 'Manual with CH- • or CH+ • .
6
Confirm with OK.
Change the time in line 'Time' using the number buttons 0,.9 on
your remote control.
8
Check 'AM/PI_, 'Year, 'Month', and 'Date' in the same way.
To select between the fields, use CH- • or CH+ • .
Change the information with 4, • or the number buttons
0..9.
9
Select one of the following settings in line 'Daylight Saving':
'On': The time set corresponds to the summer time (summer
time is on)
'Off: The time set corresponds to the winter time (summer time
is off)
When all settings are correct, confirm with OK.
To end, press SYSTEM-MENU
If the setting has been confirmed with OK the automatic system is disabled.
Time/Date
Manual
Time 09:02
AM/PM AM
Year 2003
Month 01
Date 01
Daylight Saving Off
To exit press
SYSTEM MENU
30 Installing your DVD recorder
To Next Page
Loading...
