PROBLEM SOLUTION
No playback on DVD
recorder:
`/There is no recording on the disc: Change disc.
`/You inserted the wrong disc type: Your Recorder can play the following disc types: DVD
Video, (Super)Video-CD, DVD+R(W), Audio-CD, , MP3-CDs
`/You inserted the disc the wrong way: Insert the disc with the label facing up.
`/The disc is dirty. Clean the disc.
`/Wrong region code: The region code of the DVD and the DVD Recorder must match.
`/The child lock is on. Read chapter 'Access Control (Child Lock) _
•/You have selected or set the wrong channel number on the TV for the DVD recorder: Select
the correct channel number on the TV (channel 3 or 4).
`/The cable connecting the TV and the DVD Recorder may be loose. Check the cable.
t/
Poor playback on DVD
Recorder (distorted
)icture/distorted sound)
`/Your TV is not properly adjusted.
`/The disc is dirty: Clean the disc.
`/Sometimes the picture may be temporarily distorted. This is not a defect of your DVD
recorder.
Programmed recording
does not work:
`/You have set the wrong time or date: Check time/date.
•/You have not set the TIMER properly: Check the programmed recordings (TIMER block).
•/A locked disc was inserted: Remove disc lock.
`/A finalized DVD+R has been inserted. Change disc.
There is picture or sound
interference with the TV
reception.
,/Before recording, select the recording mode as described in chapter 'Manual Recording',
section 'Selecting the recording mode (quality)'.
,/Change the modulator channel. During standby hold on the remote the button 3 pressed to
switch to channel 3. With button 4 you switch to channel 4.
,/Have your antenna or cable TV signal checked.
Before you call technical support 8 1
To Next Page
Loading...
