7
3
4
2
Put the lock cylinder into the mortise,
and then tighten the lock cylinder’s
anchor screw.
Install the set screw and connecting
screw tube on the outside
escutcheon.
Pass the connecting cable through the
hole above the door. Align the square
shaft of the outside escutcheon with
the rotary hole on the mortise, and
insert the square shaft into the rotary
hole, so that the outside escutcheon
is closely tted in the outside part of
the door.
Attention
1. Please cut the bar of the lock cylinder to a proper
length.
2. Cutting requirements: After the lock cylinder
is inserted into the mortise, leave the bar with an
extruded length of 15-30mm that is higher than
the door surface and cut the rest part. When the
cutting is done, align the mortise to put the lock
cylinder into it.
Lock cylinder
Connecting
screw tube
Connecting
screw tube
Connecting
screw tube
Escutcheon
cable
Video cable
Set screw
Lock cylinder’s
anchor screw
To Next Page
Loading...
