Philips Fidelio FB1 - Remote Control Battery Preparation; Battery Insertion and Precautions

10 EN
Prepare the remote
control
• The provided remote control allows the
unit to be operated from a distance.
• Even if the remote control is
operated within the eective range
19.7 feet (6m), remote control
operation may be impossible if there
are any obstacles between the unit
and the remote control.
• If the remote control is operated
near other products which generate
infrared rays, or if other remote
control devices using infra-red
rays are used near the unit, it may
operate incorrectly. Conversely,
the other products may operate
incorrectly.
Replace the remote control battery
Slide to remove the battery
compartment cover, insert 2 AAA
batteries (1.5V) with correct polarity,
then slide the battery compartment
cover back into position.
• Make sure the (+) and (–) ends of
the batteries match the (+) and
(–) ends indicated in the battery
compartment.
1
2
3
Precautions Concerning Batteries
• Be sure to insert the batteries with
correct positive “” and negative
“” polarities.
• Use batteries of the same type.
Never use dierent types of batteries
together.
• Either rechargeable or non-
rechargeable batteries can be used.
Refer to the precautions on their
labels.
• Be aware of your ngernails when
removing the battery cover and the
battery.
• Do not drop the remote control.
• Do not allow anything to impact the
remote control.
• Do not spill water or any liquid on
the remote control.
• Do not place the remote control on a
wet object.
• Do not place the remote control
under direct sunlight or near sources
of excessive heat.
• Remove the battery from the remote
control when not in use for a long
period of time, as corrosion or
battery leakage may occur and result
in physical injury, and/or property
damage, and/or re.
• Do not use any batteries other than
those specied.
• Do not mix new batteries with old
ones.
• Never recharge a battery unless it is
conrmed to be a rechargeable type.