20 EN
Dynamic Range Control (DRC)
You can apply dynamic range control to
Dolby Digital tracks.
• ON : Optimization the dynamic
range
• OFF : Turn o dynamic range
adjustment
• AUTO : Dynamic range is
automatically adjusted
» By default, the DRC mode is set
to AUTO.
Note
•
DRC is not available in USB/BT/Play- mode.
IMAX
Set IMAX mode auto or o.
• AUTO: Set to IMAX mode on
• OFF: Set to IMAX mode o
» By default, the IMAX mode is set
to AUTO.
Neural:X
DTS:X® technologies provide users with
virtual multi-channel virtual surround
eects, creating an immersive audio
volume.
• ON: Set to Neural:X mode on
• OFF: Set to Neural:X mode o
» By default, the Neural:X mode is
set to ON.
BASS/TREBLE
Change the low frequency (bass) and
high frequency (treble) settings of this
product.
• BAS -5 ~ BAS +5
• TRE -5 ~ TRE +5
» By default, the Bass/Treble is set
to 0.
Dialogue mode
Dialogue mode improves the clarity
of dialogue and vocals in movies, TV
programs and podcasts by adjusting the
tonal balance of this product.
• DLG 0 ~ DLG 6
» By default, the dialogue mode is
set to 0.
Tips
•
The related level value can be adjusted only
when playing DTS format source. Otherwise it
cannot be adjusted.
SYNC
Set the audio delay.
Video image processing, sometimes
longer than the time required to process
the audio signal. This is called “delayed.”
Audio Delay feature is designed to
remedy this delay.
• S 00~S 200
» By default, the audio delay is set
to 00.
Calibration
Auto calibration setup.
Tips
•
If calibration is never done before, If MIC is
inserted, navigate to the calibration item shall
always display “CALIBRATE – PRESS PLAY”.
To start auto calibration:
1 Turn on the soundbar.
2 Insert MIC to MIC IN at the rear of
FB1.
» Display “CALIBRATE – PRESS PLAY”
To Next Page
Loading...
