Philips Fidelio FB1 - Page 22

22 EN
Adjust speaker level
• Front Left : FL -5 ~ FL +5
• Front Right : FR -5 ~ FR +5
• Subwoofer : SW-5 ~ SW +5
• Center : CT -5 ~ CT +5
• Side Left : SL -5 ~ SL +5
• Side Right : SR -5 ~ SR +5
» By default, the speaker level is set
to 00.
DIM
Set display brightness.
• DIM HIGH, DIM MID, DIM LOW
» By default, the dimmer is set to
DIM MID.
DISPLAY
Set to turn o the display automatically
(except the Wi-Fi LED indicator) after 10
seconds of idle when no user operation.
• ON: Set to display on
• OFF: Set to display o
» By default, the display is set to
ON.
LIGHT
Audio light ring control.
• AUTO : When the Dolby Atmos
format is detected, the audio
light ring will turn on for 10
seconds and turn o.
• ON: When Dolby Atmos format is
detected, the halo light stays on
following the audio.
• OFF: Set to Audio light ring o
» By default, the LIGHT is set to AUTO.
Note
•
The brightness should follow DIM setting.
Standby
The unit automatically turns to Standby
mode after about 15 minutes if the TV or
the external unit is disconnected (or USB, BT
function bit playback pause), switched o.
• STNBY IN 15M: Turn on the
Auto-Standby.
• STNBY OFF: Turn o the Auto-
Standby.
» By default, the setting is set to o.
Note
•
To switch the unit o completely, remove the
mains plug from the mains socket.
• Please turn the unit o completely to save
energy when not in use.
BT PAIR
Enter the Bluetooth pairing mode.
• If you want to connect your
soundbar with another Bluetooth
device, you can activation the pairing
in the menu (BT PAIR) to disconnect
from current BT connected devices
and enter the Bluetooth pairing
mode.
» Press
> select “BT PAIR” > Then
press
(Enter) to conrm the
Bluetooth pairing mode.
• Follow step 2-3 in “Play from
Bluetooth devices“ above to pair
your Bluetooth device.
Tips
•
The “BT PAIR” menu will only be displayed
when the current signal source is in “BT” mode