EasyManua.ls Logo

Philips GoGEAR - Get Started; Charging the Player; Powering On and Off

Philips GoGEAR
37 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10 EN
3 Get started
Charge power
MUSE has a built in battery that can be charged
through the USB connector of a computer.
Connect the player to a PC by using the USB
cable.
Note
When you connect MUSE to a computer, you are
    [Charge & transfer] or
[Charge & play]. If no option is selected, [Charge &
transfer] applies.
To play the MUSE when you charge power, select
[Charge & play].
Battery level indication
The display indicates the approximate levels of
the battery status as follows:
100% 75% 50% 25% 0%
»     
the battery is low. The player saves
all settings and switches off within 60
seconds.
Note
Rechargeable batteries have a limited number of charge
cycles. Battery life and number of charge cycles vary by
use and settings.
To conserve battery power and increase the
play time, do the following on MUSE:
Set the backlight timer to a low value
(go to
> [Display settings] >
[Screen off timer]).
Switch the player on or off
Press and hold / until the player is switched
on or off.
Automatic standby and shut-down
The player has an automatic standby and shut
down feature that can save battery power.
After 10 minutes in idle mode (no play, no
button is pressed), the player switches off.

Table of Contents

Other manuals for Philips GoGEAR

Related product manuals