EasyManua.ls Logo

Philips HD8847/19 - 4.2. SteamOut Procedure

Philips HD8847/19
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
PHILIPS 4000 04 DIAGNOSTIC MODE
7/8
If temperature is over 100°C, the backlight change from GREEN to YELLOW
(HD Models) or WHITE to RED (EP Models). is is a ALERT message to
avoid heating the boiler over dangerous temperature.
ERROR: the absorbed current is KO or the temperature does not increase;
check the wiring from the boiler to the CPU/POWER board (JP19 Electrical
diagram), the wiring of the NTC temperature-sensor (JP13 Electrical diagram)
and its correctly operation.
4.2. SteamOut
is document describes the Steam-Out procedure; the application is used in order to empty the heater.
Press the Z5 button for 3sec to reset a parameters of the Grinder (Only for EP models)
e grinder parameters will be set to its initial value a screen with the text
“RESET GRINDER PARAMETERS” is shown.
ERROR: e display doesnt change, repeat the procedure.
e steam out procedure is carried out when there is the need to operate/repair parts of the hydraulic circuit
under pressure. is procedure is not mandatory, but if necessary only for the EP models, before executing the
steam out procedure, decalcify the machine taking care to remouve the Aquaclean lter from the appliance.
In case the lter on the machine is active (or its in the machine) provide the consumer with a new one.
To enter in SteamOut
e machine enters in Steam-Out mode by holding pressed together:
the “ESPRESSO LUNGO” button and the MENU button;
while switching on the machine by main switch behind the machine.
Once entered the Steam Out mode the display shows the “STEAM OUT” indica-
tion. Buttons can be released
IMPORTANT NOTE: to execute the Steam-out procedure the Ntc sensor must
work correctly; if some errors occurs on Ntc during the steam-out, the procedure
cant continue and an error message is shown on the display.
Check the wiring of the NTC temperature-sensor (JP13 Electrical diagram) and
its correctly operation.
IMPORTANT NOTE: to execute the Steam-Out procedure the DREGDRAWER
must be in place and the DOOR must be closed. If these 2 conditions are not
respected a warning message is shown on the display and the Steam-Out is inter-
rupted

Related product manuals