74
ENGLISH
Green
13
After rinsing the brew group, insert it back into its seat until it locks
into place (see the “Weekly Cleaning of the Brew Group” chapter).
Insert the drip tray and the co ee grounds drawer. Close the service
door.
12
Wash the brew group thoroughly with fresh water.
14
Press the “ ” button to select the pre-ground co ee function without
adding any pre-ground co ee into the compartment.
15
Press the “ ” button to start the co ee brewing cycle.
16
Repeat steps 13 to 14 twice. Make sure you discard the dispensed
water.
17
To clean the drip tray, place a “Co ee Oil Remover” tablet inside and
ll it 2/3rds full with hot water. Let the cleaning solution take e ect for
about 30 minutes, then rinse thoroughly.
3
1
2
2
11
Remove the drip tray and the co ee grounds drawer, empty them and
open the service door. Remove the brew group.
To Next Page
Loading...
