Philips Home Access 4000 Series - Page 11

Install the Exterior Assembly
Before installing the Exterior and Interior Assembly,
make sure the Latch Bolt is fully retracted (in the
unlocked position).
Attention
Unlocked
Locked
Measure the diameter of
the hole in the door.
1-1/2" or 2-1/8"
(38 or 54mm)
Remove the spacer
Proceed to next step
1-1/2" (38mm)
2-1/8" (54mm)
Attention
The Upper Screw & Screw Post on the top is OPTIONAL.
It is used for additional security, or when a door is weak
or warped.
10
With the Latch Bolt fully retracted (in the
unlocked position), route the cable below
the Latch Bolt, and insert the tailpiece
through the slot in the Latch Bolt.
Move the Installation Buckles on both sides of
the Interior Assembly upwards to remove the
Mounting Plate from the interior base.
11
Do not insert the key when you are installing.
Make sure the hole in door frame is drilled a minimum
of 1"(25mm) deep.
Install the Strike Plate on the door frame.
9
Attention
Reinforcement
Plate Screws
Strike Plate
Screws
(Optional)
Tailpiece
9