Philips Home Access 4000 Series - Page 9

Determine the backset and adjust the
Latch Bolt.
6
Hold the Latch Bolt in front of the door hole,

door edge. Is the slotted hole centered in
the door hole?

No adjustment is required.
Proceed to the next step.
YES
The slotted hole is
NOT centered.
Rotate and pull the
Latch Bolt as
shown to extend it.
90
0
180
0
NO
OPTIONAL: Drill a hole for Upper Screw.
5
Installing this screw onto the Exterior Assembly is OPTIONAL. It is used for additional security or when a door is weak
or warped.
Attention
2-3/4"
(70mm)
2-3/8"
(60mm)
Drilling Template
7