Philips HR7772 - Food Processor Accessories; Feeding Tube and Pusher; Blade Unit; Kneading Accessory

6 Select the speed setting that corresponds with the colour of the
accessory in the bowl. See the appropriate section below.
7 Whenyouhavenishedprocessing,turnthespeedselectorto
0 (Fig. 4).
Feeding tube and pusher
Use the feeding tube to add liquid and/or solid ingredients. (Fig. 5)
Use the outer pusher to push solid ingredients down the feeding
tube. (Fig. 6)
If the ingredients you are going to shred or slice have a small
diameter, put the outer pusher in the feeding tube to make the
feeding tube smaller. Then use the inner pusher to push the
ingredients down the feeding tube. (Fig. 7)
Tip: You can also use the inner and outer pusher to close the feeding tube.
This prevents ingredients from escaping through the feeding tube.
Blade unit
You can use the blade unit to chop, mix, blend or puree ingredients.
1 Remove the protective cover from the blade (Fig. 8).
The cutting edges are very sharp. Do not touch them.
2 Put the tool holder in the bowl. (Fig. 9)
3 Put the blade unit on the tool holder in the bowl (Fig. 10).
4 Put the ingredients in the bowl. Pre-cut large pieces of food into
piecesofapprox.3x3x3cm(Fig.11).
Note: Always put the tool holder with the blade unit in the bowl before you
add the ingredients.
5 Putthelidonthebowl(1).Turnthelidclockwise(2)toxit
(‘click’) (Fig. 12).
6 Put the pusher in the feeding tube.
7 Select the speed that corresponds with the colour of the
accessory (Fig. 13).
-
-
-
ENGLISH8
8 Whenyouhavenishedprocessing,turnthespeedselectorto0
and unplug the appliance (Fig. 4).
Tips
When you chop onions, press the pulse button a few times to
prevent the onions from becoming too nely chopped (Fig. 14).
Do not let the appliance run too long when you chop (hard) cheese
or chocolate. Otherwise these ingredients become too hot, start to
melt and turn lumpy.
Do not use the blade unit to chop very hard ingredients like coffee
beans, turmeric, nutmeg and ice cubes, as this may cause the blade to
get blunt.
The standard processing time for all chopping jobs is 30-60 seconds.
If food sticks to the blade or to the wall of the bowl, switch off the
appliance and unplug it. Then use a spatula to remove the food from
the blade or from the wall of the bowl.
Kneading accessory
You can use the kneading accessory to knead yeast dough for bread and
pizzas.
The standard processing time for all kneading jobs is 30-180 seconds.
1 Put the tool holder in the bowl (Fig. 9).
2 Put the kneading accessory on the tool holder. (Fig. 15)
Note: Always put the tool holder with the kneading accessory in the bowl
before you add the ingredients.
3 Put the ingredients in the bowl (Fig. 16).
4 Putthelidonthebowl(1).Turnthelidclockwise(2)toxit
(‘click) (Fig. 17).
5 Put the pusher in the feeding tube.
6 Select the speed that corresponds with the colour of the
accessory (Fig. 18).
7 Whenyouhavenishedprocessing,turnthespeedselectorto0
and unplug the appliance (Fig. 4).
-
-
-
-
-