Step 11. Run the Philips Upgrade Wizard Again.
IntelliVue Telemetry System Infrastructure Installation and Service Guide 3-47
12. Click Next> to continue.
If patient-worn transceivers cannot be roamed to another AP, then a dialog
appears reminding you that patient-worn devices connected to the AP will lose
data while the AP is being upgraded.
13. Click Continue to continue the upgrade process.
The wizard upgrades the APs two at a time and displays status messages about
the AP upgrade process (Figure 3-35).
The message Finished upgrading AP [AP-##] is displayed when the AP upgrade
process is complete.
Figure 3-34: Patient Worn Device Data Loss Warning
Figure 3-35: AP Upgrade Process Status Messages
To Next Page
Loading...