Importing ITS Configuration Files
IntelliVue Telemetry System Infrastructure Installation and Service Guide 5-11
Note Do NOT keep refreshing your web browser while waiting for the newly added APs to
appear in the APC web interface. Refreshing the APC web interface too frequently
will only slow down communications on the entire ITS.
c) Repeat Steps a and b until all APs have been added back to the network.
Note that all configuration files are imported in full except for the following:
• SYSTEM.TLV - This file is imported tag by tag, except for the following data which
is ignored: APC Name, System Name, Configuration Key info, Web username/
password/config info, AP_CFG_PRESIDE.
• BOOTROM NVP - This file contains the APC MAC address and static IP address/
subnet mask/default gateway. These settings should only be edited using the
bootloader serial menu on the APC.
To Next Page
Loading...