Contents
IntelliVue Telemetry System Infrastructure Installation and Service Guide v
APC Configuration Worksheet . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-29
Setting Descriptions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-29
1.4 GHz Default AP Configuration Worksheet. . . . . . . . . . . . . . . . . . . . . . . . 2-32
Setting Descriptions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-32
Blank Template . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-32
2.4 GHz Default AP Configuration Worksheet. . . . . . . . . . . . . . . . . . . . . . . . 2-33
Setting Descriptions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-33
Blank Template . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-34
AP Group Configuration Worksheet . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-35
Setting Descriptions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-35
Blank Template . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-35
Chapter 3: Installing and Configuring the ITS
High-level ITS Installation and Configuration Procedure . . . . . . . . . . . . . . . . . . . 3-2
Step 1. Complete the ITS Installation Worksheets.. . . . . . . . . . . . . . . . . . . . . . . . 3-4
Step 2. Install the ITS Infrastructure Components.. . . . . . . . . . . . . . . . . . . . . . . . 3-4
Step 3. Set Up Your Service PC. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-7
Configuring Your PC to Connect to the ITS Wireless Subnet . . . . . . . . . . . . . 3-7
Copying the Upgrade Wizard files to your PC . . . . . . . . . . . . . . . . . . . . . . . . . 3-9
Step 4. Perform Initial Configuration of the APCs to be Installed. . . . . . . . . . . . 3-12
Step 5. Add the APCs to the Network. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-14
Step 6. Run the Philips Upgrade Wizard. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-16
Compatibility . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-16
Using the Upgrade Wizard . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-17
Step 7. Verify and Configure Important ITS Settings via the APC Interface. . . . 3-21
Verifying the Filter Settings. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-21
Verifying the BOOTP/DHCP Settings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-23
Configuring the Access Point Default Settings . . . . . . . . . . . . . . . . . . . . . . . 3-25
Configuring the 1.4 GHz Access Point Default Settings . . . . . . . . . . . . . . 3-25
Configuring the 2.4 GHz Access Point Default Settings . . . . . . . . . . . . . . 3-26
Configuring AP Groups . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-28
Step 8. Run the Philips Upgrade Wizard Again.. . . . . . . . . . . . . . . . . . . . . . . . . . 3-33
Step 9. Add APs to the Network.. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-37
Step 10. Rename Installed APs and Remote Antennas. . . . . . . . . . . . . . . . . . . 3-40
Step 11. Run the Philips Upgrade Wizard Again. . . . . . . . . . . . . . . . . . . . . . . . . 3-41
Step 12. Export the ITS Configuration to a Disk File. . . . . . . . . . . . . . . . . . . . . . 3-49
Step 13. Restore your Service PC to its Original Settings. . . . . . . . . . . . . . . . . . 3-49
Step 14. Install ITS Bedside Monitors and Patient-worn Transceivers.. . . . . . . 3-50
To Next Page
Loading...