To Next PageTo Next Page
Need help?Do you have a question about the Philips L01.1E and is the answer not in the manual?
Details on reception systems, tuning, colour, sound, and A/V connections.
Describes side (or front) connections and top (or front) control interfaces.
Overview of the main chassis panels and their connectivity.
Safety regulations and precautions for performing repairs on the TV.
Recommended maintenance intervals and inspection procedures.
Important warnings regarding high voltage, ESD, and picture tube discharge.
Guidance on positioning the TV, making connections, and initial setup.
Overview and explanation of the functions of the remote control buttons.
Steps for automatic TV tuning and program storage.
Step-by-step guide for manually storing TV programs.
Instructions for switching to radio mode and tuning stations.
How to adjust picture parameters like brightness, colour, contrast, sharpness.
How to adjust sound parameters like treble, bass, balance, and volume.
Adjusting contrast+, NR, timer, child lock, and parental control.
Instructions for using the teletext service, including page selection and favourite pages.
Explanation of different screen aspect ratio modes like 4:3, Zoom, and Widescreen.
Guide to connecting video recorders, other equipment, amplifiers, and headphones.
Using the remote control to operate VCR functions.
Step-by-step instructions for removing the rear cover of the TV.
Procedures for placing the main panel in a service position.
Instructions for removing the side Input/Output panel.
Steps for properly mounting the rear cover after service.
Overview of test points on circuit assemblies for diagnostics.
Introduction to Service Default Mode (SDM) and Service Alignment Mode (SAM).
Purpose, specifications, and entry method for SDM.
Purpose, specifications, and navigation for SAM.
Purpose, entry, and exit procedures for CSM.
Troubleshooting common picture and sound problems using CSM.
Introduction and specifications for ComPair diagnostic software.
Information on the error code buffer and how to read it.
Methods for accessing and displaying error codes from the buffer.
Procedures for clearing the error code buffer.
Table listing error codes, their descriptions, and related components.
Using the front LED to display error codes, useful when there is no picture.
Common failure symptoms and suggested repair tips for diagnosis.
Overall block diagram of the TV chassis showing interconnected functional blocks.
Diagrams and descriptions of test points on the main and CRT panels.
Diagram showing I2C bus interconnections and supply voltage distribution.
Schematic diagram for the power supply unit (A1).
Table showing component variations for the power supply based on TV model.
Schematic diagram for the line deflection circuit (A2).
Component variations for the line deflection circuit by TV model.
Component variations for the NICAM/2CS/BTSC decoder by TV model.
Component variations for the front I/O and headphone panel by TV model.
Schematic diagram for the frame deflection circuit (A3).
Component variations for the frame deflection circuit by TV model.
Schematic diagram for the tuner and IF processing circuit (A4).
Component variations for the tuner IF circuit by TV model.
Schematic diagram for Video IF and Sound IF processing (A5).
Component variations for Video IF + Sound IF by TV model.
Schematic diagram for the synchronisation circuit (A6).
Component variations for the synchronisation circuit by TV model.
Schematic diagram for the control circuit (A7).
Component variations for the control circuit by TV model.
Schematic diagram for the audio amplifier and mono sound processing (A8).
Component variations for the audio amplifier by TV model.
Schematic diagram for the NICAM/2CS/BTSC decoder (A9).
Schematic diagram for the audio/video source switching circuit (A10).
Component variations for the source switching circuit by TV model.
Schematic diagram for the front I/O, control, and headphone panel (A12).
Schematic diagram for the rear I/O SCART connectors (A14).
Schematic diagram for the tilt and rotation panel (A15).
Component variations for the tilt and rotation panel by TV model.
Component layout diagram for the large signal panel (top view).
Component layout mapping for the large signal panel (top and bottom views).
Component layout diagram for Part 1 of the large signal panel (bottom view).
Component layout diagram for Part 2 of the large signal panel (bottom view).
Component layout diagram for Part 3 of the large signal panel (bottom view).
Component layout diagram for Part 4 of the large signal panel (bottom view).
Schematic diagram for the CRT panel (B1).
Component variations for the CRT panel by TV model.
Schematic diagram for the SCAVEM panel (B2).
Component variations for the SCAVEM panel by TV model.
Component layout diagram for the CRT and SCAVEM panels (top view).
Component layout diagram for the CRT and SCAVEM panels (bottom view).
Schematic diagram for the side AV and headphone panel (C).
Component layout diagram for the side AV and headphone panel (top view).
Schematic diagram for the side AV and headphone panel (E1).
Component layout diagram for the side AV panel and headphone (top view).
Schematic diagram for the top control panel (RF) (T).
Component layout diagram for the RF top control panel.
Schematic diagram for the top control panel (FSQ) (T1).
Component layout diagram for the FSQ top control panel.
Conditions required for performing electrical adjustments and alignments.
Procedures for hardware adjustments like Vg2 and focus.
Overview of software alignments available in SAM.
Explanation of option bytes (OB1-OB7) and their settings.
Definitions for option bits related to China, Virgin Mode, UK PNP, ACI, ATS, LNA, FM Radio, Philips Tuner.
Definitions for option bits related to Hue, Color Temp, Contrast+, and Tilt.
Option setting for Automatic Volume Level functionality.
Option setting for Wide Screen software usage.
Option setting for EU/AP PAL stereo system with MSP 3415.
Alignment procedures for Tuner, IFPLL, AFW, AGC, YD, CL, AFA/AFB.
How to adjust AGC value for optimal video input.
Adjusting black cutoff level for Normal, Cool, and Warm color temperatures.
Aligning picture geometry parameters like horizontal and vertical adjustments.
Table of default geometry values for different screen sizes.
Default audio settings and alignment values.
Overview of the L01 chassis, its architecture, and main components.
Description of audio signal paths for mono and stereo sound.
Overview of the video signal processing path.
Process of RF signal reception, amplification, and IF development.
How picture parameters are adjusted and cut-off stabilisation is achieved.
Description of horizontal and vertical deflection systems.
How the horizontal drive signal is generated and controlled.
Vertical synchronisation and drive signals for the vertical deflection amplifier.
Explanation of linearity correction, Mannheim Effect, and S-Correction.
Description of the Switching Mode Power Supply (SMPS).
Overview of the SMPS, its benefits, and operation.
Voltages supplied by the secondary windings of T5520 and LOT.
Explanation of Quasi-Resonant behaviour and frequency characteristics.
Mode to prevent component damage during fault conditions.
Conditions under which the set enters Standby mode.
Overview of SMPS protection features.
Protects output voltage by averaging and switching off the MOSFET.
Limits 'sense' voltage on pin 5 to protect against over-current.
How the microprocessor controls the TV functions.
How the microprocessor communicates with external devices via I2C-bus.
Control lines for input/output selection (STATUS1, STATUS2).
Signals controlling the power supply (Stdby_con, POWER_DOWN).
How UOC pin 3 selects the appropriate SAW filter for different systems.
Protection events controlled by UOC: BC, I2C, and general protection.
List of abbreviations used in the manual.
List of spare parts for the mono carrier.
List of various spare parts including fuses, holders, and connectors.
List of various spare parts including resistors and capacitors.
List of various spare parts including transistors, diodes, and ICs.
List of spare parts for the CRT panel.
List of spare parts for the side AV panel.
List of spare parts for the front interface.
List of spare parts for the top control panel.
List of various spare parts for the top control panel.
List of spare parts for the side AV panel.
General
