Disassembly Procedures (A1)
74 Chapter 6 - Disassembly Guide
Procedure to remove handle and foot cushions:
Each end of the handle is friction-fit onto a cross-shaped boss.
1. Use flat-bladed screwdriver to carefully pry one end of the handle.
2. When the end of the handle has begun to loosen from the boss, use the
same technique to begin to pry up the other end.
3. Alternately apply this prying action between each end of the handle until
the handle is free of the rear case.
4. The foot cushions are attached with an adhesive to the bottom surface of
the rear cover, and can be removed by lifting one end of the foot and
peeling off.
To Next Page
Loading...
