Disassembly Procedures (A3)
84 Chapter 6 - Disassembly Guide
Procedure to remove the recorder and the battery housing:
1. Remove the battery as described in the procedure on page 83. Carefully
remove the two foam battery pads from the battery housing.
2. If a recorder is installed, remove it as described in the procedure on
page 78.
3. If a recorder is not installed, remove the recorder blanking cover by
slipping a small flat-blade screwdriver into one of the slots on the
blanking cover. Use a screwdriver to gently depress the snap-tab on the
inside of the cover, while pulling the cover away from the monitor. After
the first tab is released, repeat the process on the other side of the cover
and remove cover.
4. On the rear panel of the monitor, remove the three screws fastening the
battery housing.
Recorder housing
To Next Page
Loading...
