Disassembly Procedures (A3)
86 Chapter 6 - Disassembly Guide
Procedure to remove fuses:
1. Remove the AC power input fuses, as shown, using the fuse pullers.
Procedure to remove the power supply assembly:
1. On the rear panel of the monitor, remove the eight screws holding the
power supply assembly.
2. Carefully lift the power supply assembly from the rear case.
3. The power supply assembly can be disassembled into the following
elements:
• Power supply PCB
• NiBP pump
• Heat sink/chassis
• Main ribbon cable
Fuse F1
Fuse F2
Screws fastening the power supply assembly
To Next Page
Loading...
